Nvram Initialize - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
Example:
P460-1(super)# no username john
User account removed.
If you wish to delete a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".
You cannot delete the default user account "root".

nvram initialize

User level: read-write, admin.
Use the nvram initialize command to reset the configuration parameters to
their factory defaults on the Active and Standby Supervisor modules.
The syntax for this command is:
nvram initialize {switch | all}
switch
all
Example:
P460-1# nvram initialize
This command will restore factory defaults, and can
disconnect your telnet session
*** Reset *** - do you want to continue (Y/N)? y
Connection closed by foreign host
The nvram initialize command does not alter the Active/Standby status of the
Supervisor modules.
62
Resets all the switch information (Layer 2 only).
Resets all parameters including routing parameters in the
switch.
Avaya P460 Reference Guide