Parity - Datalogic QuickScan I QM2131 Product Reference Manual

RS-232 ONLY Interface

Parity

This feature specifies parity required for sending and receiving data. A parity
check bit is the most significant bit of each ASCII coded character. Select the
parity type according to host device requirements.
•
•
•
DEFAULT
$CR2PA01
Parity = Even
Product Reference Guide
Select None when no parity bit is required.
Select Odd parity and the parity bit value is set to 0 or 1, based on data, to
ensure that an odd number of 1 bits are contained in the coded character.
Select Even parity and the parity bit value is set to 0 or 1, based on data, to
ensure that an even number of 1 bits are contained in the coded character.

Enter/Exit Programming Mode
$CR2PA00 
Parity = None
$CR2PA02 
Parity = Odd
29