Troubleshooting - Eneo DIR-4108H Series Operating Instructions Manual

Operating Instructions

TROUBLESHOOTING

PROBLEM
No Power
No Live Video
No Live Video on the VGA
Monitor
DVR has stopped recording.
The icon displays, however,
the DVR is not recording.
IR remote control does not
work properly.
56
Check power cord connections.
Confirm that there is power at the outlet.
Check camera video cable and connections.
Check monitor video cable and connections.
Confirm that the camera has power.
Check camera lens settings.
If the DVR does not detect a VGA monitor automatically, press and hold the DISPLAY
button on the remote control for 5 seconds or longer to switch the video output from Video
out to VGA out.
If hard disk drive is full, you will either need to delete video or set the DVR to the Recycle
On (Recycle When Disk Full) Mode. See Chapter 2 – Installation & Configuration,
Main Setup – Record Setup for details.
When the DVR is in the Pre-Event recording mode, the yellow
when there is no event, and the DVR is not recording. The red
when any event occurs and the DVR starts recording.
Check the batteries in the remote control.
Check that nothing blocks the infrared sensor on the DVR.
Check the system ID setting for the remote control. See Chapter 2 – Installation &
Configuration, Main Setup – System Setup for details.
POSSIBLE SOLUTION
and icons display
and icons display