Eneo DIR-4108H Series Operating Instructions Manual page 28

Operating Instructions
Network Settings (NETWORK
Type: Select the type of network configuration from: Manual, DHCP and ADSL (with PPPoE).
Manual – You can select Manual when using a static IP address for network connection. Set up LAN parameters manually.
Set the numbers of the IP Address, Gateway and Subnet Mask.
DHCP – You can select DHCP when the DVR is networked through DHCP (Dynamic Host Configuration Protocol). The
DVR reads the IP address from DHCP network when selecting the Save button.
ADSL – You can select ADSL (with PPPoE) when the DVR is networked through ADSL. Enter the ID and password for
ADSL connection, and the DVR receives the IP address when selecting the Save button.
NOTE: Ask your network provider for your network connection type and connection information.
NOTE: If the DVR is configured for DHCP or ADSL, the IP address of the DVR might change whenever the unit
is turned on. If you want to use the DVRNS function, you will need to get the IP Address of the DNS Server from
the Internet service provider.
DNS Server: Set the DNS server IP address obtained from your network administrator. If you set up the DNS Server,
the domain name of the DVRNS server or SMTP server instead of the IP address can be used during DVRNS Server
or Mail setup.
Port Number Setup...: Set the port number of each remote software related program.
NOTE: You will need to get the appropriate Port Numbers for each remote software related program from your
network administrator. Do NOT use the same port number for two different programs, otherwise, the DVR cannot
be connected with the PC running RAS or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the
PC running RAS or WebGuard.
26
Network Tab)