Eneo DIR-4108H Series Operating Instructions Manual page 25

NOTE: The system performance might be affected when a large quantity of text inputs are detected from several
channels at the same time.
Port – Select the port from None, RS232, RS485 and USB-Serial (1~8). If you have set the Port as None, you will not be
able to make any changes to the screen.
NOTE: When using the USB to serial text-in device, do NOT remove the USB cable from the port while the system
is running.
Setup... – Set the port settings. Use the ATM or POS manufacturer's recommended settings when configuring the RS232,
RS485 or USB-Serial ports.
Text-In Product – Select your text input device from the list.
Transaction Start – Enter the transaction start string. Refer to the device manufacturer's documentation for the text string
that the device first sends when a transaction starts.
Any Character – Check the box to turn it On or Off. If you want the DVR to react to any character sent from the text input
device, you will want to turn On Any Character
Transaction End – Enter the transaction end string. Refer to the device manufacturer's documentation for the text string
that the device sends when a transaction ends.
more line(s) – Select the number of additional lines of text that you want the DVR to record.
Line Delimiter – Enter the character(s) that the device uses to indicate the end of a line. Special characters can be created
using ^ and a capital letter; e.g., ^J for NL (New Line), ^M for CR (Carriage Return). Refer to the device
manufacturer's documentation for Line Delimiter character(s).
Ignore String – Enter any strings of text that you want the DVR to ignore. Refer to the device manufacturer's documentation
for text strings that the device sends during transactions, so you will know which ones you do not want recorded.
Case Sensitive – Check the box to turn it On or Off. Refer to the device manufacturer's documentation to determine if
the text strings are Case Sensitive. If the device distinguishes between upper and lower case letters, make
certain the Case Sensitive box is turned On.
Time Out – Set the length of time to wait for the new text string. The DVR will consider a transaction complete if no new
text strings are entered between the last text input and the dwell time out.
Title: Change the name of all or each text input.
Actions: Set up actions the DVR will take whenever it senses text input.
Record – Select the cameras to be associated with the text input. The DVR starts recording video from all the associated
cameras when the DVR detects text input.
Alarm-Out – Select the alarm-out signals (Alarm-Out and Beep) to be associated with the text input. The DVR will alert
you of the event by activating an external alarm or internal buzzer when an input is detected on the selected
text input.
Notify – Select Mail if you want to send an e-mail to the address set during NETWORK – Mail setup when the DVR detects
an input on the selected text input.
PTZ – Select the preset position, where you want PTZ cameras to move to setup when the DVR detects an input on the
selected text input.
NOTE: For the Notify action to work, the Mail should be enabled in the NETWORK – Mail setup.
.
Digital Video Recorder
23