Table of Contents
Advertisement
Chapter 2 — Installation & Configuration
REAR PANEL CONNECTORS
No special tools are required to install the DVR. Refer to the installation manuals for the other components that make
up part of your system. Your DVR should be completely installed before proceeding.
Video In
Factory Reset Switch
Your DVR can be used with either NTSC or PAL equipment.
NOTE: You cannot mix NTSC and PAL equipment. For example you cannot use a PAL camera and an NTSC
monitor.
Connecting the Video Input
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Connecting the Monitor
A VGA connector is provided so that you can use a standard, multi-sync computer monitor as your main monitor. Use
the cable supplied with your monitor to connect it to the DVR. The VGA monitor is automatically detected when you
connect it.
NOTE: It is possible that the DVR will not automatically detect a VGA monitor if the monitor does not support
the auto detect function. In this case, press and hold the DISPLAY button on the remote control for 5 seconds or
longer to switch the video output to VGA out. Pressing and holding the button for 5 seconds or longer again returns
to the composite video output mode.
16-Channel DVR rear panel
Video Out
RS-485 Port
RS232C Port
Network Port
Digital Video Recorder
Alarm Input/Output
Power Connector
5
Advertisement
Table of Contents
