Infrared Remote Control - Eneo DIR-4108H Series Operating Instructions Manual

INFRARED REMOTE CONTROL

ID Button
If a DVR System ID is set to 0, the infrared remote control will control that DVR without any additional entries. (Refer
to the Main Setup section in this chapter for further information on setting the System ID.) If the DVR system ID is 1 to 16,
you must to press the ID button on the remote control followed by the number button (1 to 16) in order to control that
DVR. If two or more DVRs have the same ID, those DVRs will react to the infrared remote control at the same time.
DISPLAY Button
Pressing the DISPLAY button toggles between different display formats. The available formats are: full, 4x4, 3x3,
2x2 and PIP.
When the DVR does not detect a VGA monitor automatically, pressing and holding the button for 5 seconds or longer
will toggle the video output between the composite video output and VGA out.
SEQUENCE Button
When in the Live Monitoring mode, pressing the SEQUENCE button displays live channels sequentially.
ID Button
DISPLAY Button
SEQUENCE Button
FREEZE Button
ALARM Button
CAMERA Buttons
PTZ Control Buttons
(FOCUS, PRESET, ZOOM)
MENU Button
PTZ Mode Button
Arrow Buttons
Enter Button
ZOOM Mode Button
PLAYBACK Buttons
(Stop, Pause, Play, RW, FF, Previous, Next)
Digital Video Recorder
9