Table of Contents
Advertisement
LX9000 Version 2.6
5.1.6.2
Airspace
In this dialogue you can define the airspace map presentation. Check the Show airspace
item to enable airspace displays in navigational pages. If this item is unchecked no airspace
will be displayed.
In the Type panel you can specify how each airspace type is displayed. You should define
each type of airspace zone separately. First choose an airspace type from the list. Zoom
value defines to which zoom level this type is going to be visible. The Colour item specifies
airspace zone colour. You can also modify transparency of the selected type. Turn the
lower-left knob to change the transparency value. 100% means completely transparent and
only the airspace zone outline will be shown.
recommended). If the Show inactive zones option is checked then airspace zones with
proximity warning switched off will be shown.
eliminate airspace which is going to be too high for the day. For example, if the forecasted
cloud base is to be 1500 m, set this value to 1600 m and your screen will be much more
readable.
Press the DEFAULT button to reset these settings back to default.
5.1.6.3
Way Points and Airports
The way point and airport look and feel is defined in this dialogue.
waypoints item to enable way points and airports display in navigational pages. If this item
is unchecked no way points will be displayed.
0% means completely solid (not
Use Show only airspace below to
Page 35 of 130
September 2011
Check the show
Advertisement
Table of Contents
