Table of Contents
Advertisement
LX9000 Version 2.6
All necessary electronics is built into the top of the stick and only the wires from the control
tube to the interface unit need to be used. This solution makes the installation very easy.
Additionally two shielded cables are used for speed command key and PTT.
Do not forget to set the speed command input setting to TASTER (see Chapter
5.1.12.1).
The original stick grip should be removed and replaced with the new one. On the top of the
new grip there are 9 push buttons. An additional button positioned on the front side is for
climb/cruise change over. Both the PTT and climb/cruise buttons are wired separately. All
remaining buttons are connected to the built-in microcontroller and only four wires should be
connected to the RS485 system bus. A very small interface printed circuit board connects
four wires coming out of the stick to the 485 System bus.
After installation there is no special setting required on LX9000 side as the remote
stick will be automatically detected.
Use the left/right arrow to zoom in and out. Use the up and down arrow keys to toggle
between pages within the current mode. Press the upper-right button to enter the next
mode. Press the upper-left button to move to the previous mode.
10.7 Secondary Vario Indicators
An unlimited number of secondary vario indicators can be connected to the system bus.
RS485 splitting units should be used to extend the bus capacity.
secondary units depends on settings made in setup (see chapter 5.1.12.2).
Each unit has two female nine-pin connectors on the back side. Both connectors are 100%
pin to pin compatible and it doesn't matter which will be used.
operated unit can be any time connected to a free connector port of the vario indicator.
Page 128 of 130
September 2011
The functionality of
Any other RS485 bus
Advertisement
Table of Contents
