Table of Contents
Advertisement
LX9000 Version 2.6
Each further indicator (available as option) has a DIP switch on the rear side that sets and
identifies the indicator and enables it to be programmed under that identification.
positions of the switches are listed below.
After identification the needle and the two numerical displays of each indicator can be
programmed to display the following parameters:
The vario indicator built into the USB-D is always Indicator 1.
5.1.12.2.3
LCD Vario indicator
This is type of the oldest vario indicator. An LCD vario indicator consists of:
•
Needle
•
Two numerical displays (upper and lower).
•
Labels and indicators.
These following functions can be set (see next picture):
•
Needle: vario needle (Vario, SC, Netto or Relative).
•
SC Ring: Displays speed command at all times.
•
Upper Numeric Display: Integrator, time, flight time, task remaining time. Upper line;
the parameter displayed can be configured in both Vario and SC modes.
•
Vario Mode Indicator: Shows current flight mode (vario or speed command).
•
Lower Numeric Display: Altitude (NN altitude), Distance (distance to the navigation
point), Glide diff. (final glide altitude difference), Speed (TAS), Leg speed (speed on leg),
QNH (ft) (NN altitude in ft), Flight levels. Lower line; the parameter displayed can be
configured in both Vario and SC modes.
The labels will automatically be displayed depending on the current function.
warning will be displayed when the supply voltage is below 11 volts.
SW 1 ON
Indicator set1
SW 2 ON
Indicator set2
SW 3 ON
Indicator set3
All OFF
Indicator set4
Page 54 of 130
September 2011
The
The BAT
Advertisement
Table of Contents
