Table of Contents
Advertisement
LX9000 Version 2.6
•
Event is used to log an event. The recording rate will be increased to 1 second for one
minute. A message
•
Send is available only with two-seat configurations with the LX9000D. Press this button
to send the task to the rear seat device. This action will force a change of task on the
rear seat device.
•
Night will reduce backlight to level acceptable for flying in very dark conditions.
•
Off will switch off the instrument.
displayed.
5.7.1
Task Edit
Press the EDIT button and the task edit dialogue will open.
manipulated within this dialogue. A list of task points is shown. In the upper-left corner the
type and total distance is displayed. In the upper-right corner the task time is shown. Use
the lower-right knob to select task points or task time control.
There are numerous actions available within the task edit dialogue to make creation of tasks
as easy as possible.
Press the MORE>> button to see more options. Available actions are:
•
Press the EDIT button to enter a new task point, edit an existing one or to enter task
time.
•
OK action will confirm changes to the task and return to the navigational page.
•
CANCEL action will cancel all modifications of the task and return to the navigational
page.
•
Use the ZONE button to modify the observation zone for selected point. The default
zone style is defined in the Observation Zones menu in setup mode (see Chapter 5.1.8).
•
OPTIONS action will open a new dialogue where additional properties for the task can
be defined. The task name is set in this dialogue.
•
Press LOAD to load the task from the active way point file.
•
Press SAVE button to store the task to the active way point file. This task can later be
loaded from the active way point file.
•
INVERT action will invert the complete task.
•
INS PNT will insert a new point above the current cursor position.
•
DEL PNT will delete a point at the current position.
•
CLEAR will completely erase the task.
•
MOVE UP is used to move selected point upwards within the task.
•
MOVE DN is used to move selected point downwards within task.
"Event marked"
will be shown on the screen.
Page 86 of 130
"LX9000 switching off"
The Message
September 2011
will be
A task is created and
Advertisement
Table of Contents
