Table of Contents
Advertisement
LX9000 Version 2.6
To change the mode of operation, press the MODE button for approximately 2
seconds. If the radial LEDs run from top to bottom this means change over to
nearest mode and vice versa. After any power off followed by power on the
mode active before switching off will remain.
10.1.1.1
Obstacles
Flarm unit is capable of storing co-ordinates of obstacles which could cause a collision during
flight. This data is available on
update obstacles.
obstacle warning will be activated if an obstacle is found in front of the glider and a collision
risk is predicted. After a low level warning has been activated two upper LEDs will be active
(such a situation will never appear with glider v glider collision risk). Medium and high risk
will be indicated with more LEDs active and higher frequency audio signal.
To change the audio warning volume, briefly press the mode selector; each press will
increase the audio volume (three levels and mute available).
To change the mode of operation, press the MODE button for approximately 2
seconds. If the radial LEDs run from top to bottom this means a change over to
nearest mode and vice versa. After each new power on the unit will start in
Nearest mode.
10.1.1.2
Settings for the LX Flarm LED Display
Using the MODE key it is possible to adjust some parameters of the external display.
Disconnect the unit, press the MODE selector and hold. Power on and hold the MODE
selector for about 4 seconds. The display parameters can be defined by pressing the MODE
selector for approximately 2 seconds and observing green LEDs.
parameters briefly press MODE and observe the red LEDs.
Parameter LED
Twin cfg.
Tx
Baud rate
Tx+Rx 4800 bps
In conjunction with the LX9000 use exclusively 19200 bps.
If two units work in parallel (two-seat aircraft) one unit must be designated PIC and the
other PAX.
www.flarm.com
The unit is factory pre-loaded with current obstacle database.
Red
LED
Red
018˚
054˚
PIC
PAX
9600 bps
Page 114 of 130
(see Chapter 10.1.4). Use Flarm tools to
LED
Red LED
Red
090˚
LED126˚
19200 bps -------
September 2011
An
To move between
Red
Red LED
LED162
198˚
˚
38400
57600
bps
bps
Advertisement
Table of Contents
