Table of Contents
Advertisement
LX9000 Version 2.6
Ground speed and pressure altitude are also shown in the message. At the bottom two
buttons are displayed. Use the CLOSE button if this was not a valid start and you want to
remove the message from screen. If message is removed it will appear again next time you
leave the start zone. If you press the START button navigation will be advanced to the first
turning point.
There is no need to press START inside the start observation zone. You may
press it any time after leaving the start observation zone or crossing the start line.
The LX9000 will always take the correct time as start time.
If for some reason you miss the start message you may always start the task by pressing the
START button. Go to task mode and press any button. In the top row the START button is
shown. Press this button and navigation will be advanced to the next turn point.
In case you change the task in the air and you are already flying towards first turn point you
will still be able to start a task. Press the START button and a message dialogue to confirm
task start will be opened.
7.2.2
Restarting Task
If for some reason you decide to abandon the task and you would like to restart the task go
to task mode and press any button. In top row the RESTART button is shown. Press it.
Page 101 of 130
September 2011
Advertisement
Table of Contents
