Table of Contents
Advertisement
LX9000 Version 2.6
UPPER NUMBER
SHOWS INTEGRATOR
LOWER NUMBER
SHOWS
TAS/60' SPEED
NEEDLE
SPEED
COMMAND RING
LOWER NUMBER
SHOWS
ALTITUDE /
DISTANCE /
FINAL GLIDE
NEEDLE SHOWS
VARIO
NEEDLE SHOWS
RELATIV
5.1.12.3
Flarm*
On the Flarm setup page, information about Flarm serial number, version, database and
Flarm status is shown.
Device ID shows the Flarm unique ID, which is transmitted to other FLARMs. The Flarm
status message is normally OK. In case of any errors or warning an error message will
appear.
The user can change the operation mode of Flarm unit, frequency and
enable/disable competition mode.
Three operation modes are available:
•
Power OFF - Flarm unit is switched off.
•
Power ON - Flarm unit is switched on.
•
Privacy ON - Flarm unit works in stealth mode. Other Flarm units will not receive
altitude and vario information concerning your glider. For collision warnings this mode
has no influence.
•
Ext.(PC) – Use this mode when you want to receive externally connected Flarm on PC
port.
UPPER NUMBER SHOWS
TIME /FLIGHT / TASK
NEEDLE SHOWS
NEEDLE
NETTO
SHOWS SPEED
COMMAND
Page 55 of 130
UPPER NUMBER
DISPLAY
SPEED COMMAND
MODE
VARIO MODE
INDICATOR
GPS STATUS INDICATOR
OFF = NO GPS
BINKS = GPS BAD
ON = GPS OK
LOWER NUMBER
NEEDLE SHOWS
DISPLAY
INDICATED AIR
SPEED (NOT
USED)
September 2011
LOW
BATTERY
INDICATOR
Advertisement
Table of Contents
