Bulb Replacement; Headlamp; Front Park/Turn Signal - Jeep 2010 Wrangler Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 268 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 43BE3813
/chry_pdm/chrysler/owners/wra/og
Center High-Mounted Stop Lamp (1) . . . LED
(Serviced at Authorized Dealer)
Front Fog Lamps (2) . . . . . . . . . PSX24W
Rear Fog Lamps (2) . . . . . . . . . . P27/7W
Front Direction Lamps (2) . . . . . . . P27/7W
Front Side Repeaters/Side Marker Lamps
(2). . . . . . . . . . . . . . . . . . . . . . W5W
Headlamps (2) . . . . . . . . . . . . . . . . H4
Front Position Lamps (2) . . . . . . . 12V14W
Stop/Rear Position Lamps (2) . . . . . P27/7W
Rear Direction Lamps (2). . . . . . . PY27/7W
License Lamp (2) . . . . . . . . . . . . . W5W
NOTE:
Numbers refer to commercial bulb types
that can be purchased from your local au-
thorized dealer.
If a bulb needs to be replaced, visit your
authorized dealer or refer to the applicable
Service Manual.

BULB REPLACEMENT

NOTE:
Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as
266
atmospheric conditions change to allow the
condensation to change back into a vapor.
Turning the lamps on will usually accelerate
the clearing process.

Headlamp

1. Open hood and support using prop rod.
2. Remove the front grille. Turn the retainers
along the top 1/4 turn counterclockwise and
remove.
3. Pull the bottom of the grille away starting at
one side and working toward the other.
4. Turn both park and turn signal socket as-
semblies 1/4 turn counterclockwise and re-
move.
5. Remove the four screws holding the metal
retaining ring.
6. Remove the lamp from the collar.
7. Grasp the bulb and turn 1/4 turn counter-
clockwise.
8. Pull the bulb from the housing.
9. Push connector locking tab to the unlock
position.
10. Remove connector from bulb.
11. Push connector onto new bulb base, and
push the connector locking tab to the lock
position.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
12. Reinstall bulb housing. Rotate the bulb 1/4
turn clockwise.

Front Park/Turn Signal

1. Remove the front grille. Turn the retainers
along the top 1/4 turn counterclockwise and
remove.
2. Pull the bottom of the grille away starting at
one side and working toward the other.
3. Turn the socket assembly 1/4 turn counter-
clockwise and remove from housing. Pull the
bulb straight from the socket to replace.