Section 3: INSTALLATION
3.3
Turn the Projector On
1. Ensure that the power cord and signal cable are securely connected. The
Power button on the built in keypad is illuminated.
2. Turn on the projector by pressing "
on the built-in keypad. The Status LED is Green with a long blink.
3. Turn on the source. Select Input Key on the remote control to select an
input source (VGA, BNC, HDMI, Component, S-Video or Composite
Video).
4. The projector detects the source you selected and displays the image.
NOTE:
The first time the projector is used, the preferred language may be selected from the main
menu after the startup screen is displayed.
3.4
Turn the Projector Off
1. Press " " on the built-in keypad or on the remote control to turn off the
projector. A warning message appears on the displayed image.
2. Press " " again to confirm your selection. If you do not press " " again,
the warning message disappears after three seconds.
3-3
1 3
1 2
Power on
" on the remote control or press " "
020-000772-02 Rev.1 (08-2015)
1 2
1 2
Power on
SHUTTER
VGA
BNC
HDMI1
HDMI2
DVI-D
DP
3G-SDI
HDBaseT
CVBS
PRESENT.
1 3
Input Key
H Series User Manual