Initial Set Up Procedures - Raymarine a65 Installation And Operation Instructions Manual

Symbol
Getting started
Description
Power steering active.
Wind Vane mode is active.

6.21 Initial set up procedures

Once your display has been installed and commissioned, Raymarine
recommends that you perform an initial set up procedure.
Startup wizard
1
3
5
When you power-up the display for the first time or after a system
reset a Startup Wizard is displayed. The wizard guides you through
the following initial settings:
1. Language selection
2. Vessel type selection
3. Configure units
4. Boat details (minimum safe depth, total fuel capacity and
economy units.)
5. Finish
Note: These settings can also be set at any time using the menus
accessible from Homescreen > Customize.
Additional settings
In addition to the settings covered by the Wizard, it is also
recommended that the following initial set up tasks are completed:
• Set your date and time preferences.
• Adjust the display brightness (and set up a shared brightness
scheme if appropriate).
• Align the touchscreen (HybridTouch displays only).
• Designate the data master.
• Select the GPS data source.
• Familiarize yourself with the Simulator Mode.
Setting the vessel minimum safe depth
With the homescreen displayed:
1. Select Customize.
2. Select Boat Details.
3. Select Min. Safe Depth.
4. Adjust the setting as appropriate.
Note: The units for the depth measurement are based on those
specified in the Homescreen > Customize > Units Set-up >
Depth Units menu.
Setting time and date preferences
With the homescreen displayed:
1. Select Customize.
2. Select Time and Date Set-up.
3. Use the Date Format, Time Format, and Local Time: UTC
menu items to set your time and date preferences.
2
4
D12568-1
83