Radar Scan Speed; Radar Scanner Status Symbols - Raymarine a65 Installation And Operation Instructions Manual

Raymarine new a/c/e series multifunction display
Hide thumbs Also See for a65:
Table of Contents

Advertisement

13.2 Radar scan speed

SuperHD open array radars with software version 3.23 or above or
HD radomes support multiple scan speeds.
Radar scan speed is set up using the Radar Set-up menu. When
the system detects a scanner that is capable of operating at both 24
RPM and 48 RPM, 2 options are provided for scanner speed:
• 24 RPM
• Auto
If you have a radar scanner that only operates at 24 RPM, the
scanner speed option is disabled. If the scanner speed option is
enabled, you must select the Auto option if you want to use the
higher scan speeds. This option automatically switches between the
24 RPM and 48 RPM scan speeds as appropriate.
Selecting radar scan speed
The speed option requires a 48 RPM compatible Raymarine HD
radome or Raymarine SuperHD open array radar scanner.
Select your radar scanner speed from within the radar application.
1. Select Menu.
2. Select Scanner Set-up.
3. Select Scanner Speed
4. Select the required scanner speed:
• Auto
• 24 RPM
The Auto option automatically selects the appropriate speed
for your radar range. 48 RPM is used at radar ranges of up
to 3 nm. It provides an increased refresh rate, which is useful
at high speed or in areas where you have large numbers of
radar targets. At radar ranges of greater than 3 nm the display
switches the radar speed to 24 RPM.
Using radar

13.3 Radar scanner status symbols

The radar scanner power mode status is indicated in the databar.
Radar
power
Symbol
mode
Transmit
(TX)
Standby
(STBY)
Off
Timed
Transmit
Powering the radar scanner on and off
In the radar application:
1. Select Menu.
2. Select Power to switch the Radar's power On and Off.
The radar will always power up in Standby mode.
3. Select Radar to switch the radar between Transmit and Standby
modes.
Using the power button to switch operating
modes
The radar operating modes can also be set using the multifunction
displays power button menu.
1. Press and release the Power button.
The shortcuts menu is displayed:
Description
Rotating icon, signifying that the scanner is
on and transmitting. When SCANNER is
set to ON, select this mode to activate the
scanner. This is the usual mode of operation.
Static icon, indicating that the scanner is on
but not transmitting, and the antenna is not
rotating. The scanner does not transmit and
the radar data is removed from the screen.
This is a power-save mode used when the
radar is not needed for short time periods.
When you return to transmit mode, the
magnetron does not need to warm up again.
This is the default mode.
Scanner powered off when radar not required,
but display is in use for other applications,
such as the chart. When selected, the system
counts down. During this time you cannot
re-power the scanner.
Scanner switches between on/transmitting,
and standby mode. Scanner goes into power
save mode when constant use of radar is not
required.
141

Advertisement

Table of Contents
loading

This manual is also suitable for:

A67C97C125E7C127E95 ... Show all

Table of Contents