Raymarine a65 Installation And Operation Instructions Manual page 47

600 watt sonar-compatible sonar transducer connection via
optional adaptor — Sonar variant multifunction displays
1
1. Rear connector panel of multifunction display (Sonar variant).
2. E66066 adaptor cable.
3. Sonar transducer.
Transducer adaptor cable
Cable
0.5 m (1.64 ft) transducer adaptor
cable
Sonar transducer connection — Non-Sonar variant
multifunction displays
hs
SeaT alk /
RayNet
SeaT alk
3
1. Rear connector panel of multifunction display (Non-sonar
variant).
2. Raymarine network switch (only required if connecting more
than one device using SeaTalk
3. RayNet cable.
4. Raymarine sonar module.
5. Sonar transducer cable.
6. Sonar transducer.
Minn Kota sonar transducer connection via optional adaptor
cable (Sonar variant multifunction displays only)
1 2
1. Rear connector panel of multifunction display (Sonar variant).
2. Minn Kota transducer adaptor cable.
3. Minn Kota transducer cable.
4. Minn Kota transducer.
Cables and connections
2
3
Part number
E66066
1
4 2
hs
/ RayNet
hs / RayNet).
3
Sonar variant multifunction displays
The table below details which multifunction display variants feature
a built-in sonar module and can be connected directly to compatible
sonar transducers.
Sonar variants
a67
e7D
c97
c127
D12257-1
e97
e127
Minn Kota transducer adaptor cable
Connects a Minn Kota sonar transducer to a compatible Raymarine
multifunction display.
Cable
1 m (3.28 ft) Minn Kota transducer
adaptor cable
Thermal camera connection
You can connect a thermal camera to your New c Series or New
e Series multifunction displays.
Note: New a Series does not support thermal cameras.
The camera is connected via a Raymarine network switch. If
you want to use the optional Joystick Control Unit (JCU) with the
camera this must also be connected to the network switch. A
composite video connection is required between the camera and
the multifunction display.
5
6
D12258-1
1. Multifunction display
2. Raymarine network switch
4
3. Joystick Control Unit (JCU), optional
4. SeaTalk hs
5. Ethernet cable coupler.
6. PoE (Power over Ethernet) injector (only required if using the
optional JCU).
D12259-1 7. Thermal camera
8. Video connection
Important notes
• You can control the thermal camera using your multifunctional
display. The Joystick Control Unit (JCU) is optional, but can be
Non-sonar variants
a65
e7
c95
c125
e95
e125
e165
Part number
A62363
1
hs
SeaT alk / RayNet
hs
SeaT alk / RayNet
8
7
to RayNet cable
hs
SeaT alk / RayNet
D12260-1
47