Raymarine a65 Installation And Operation Instructions Manual page 60

1. Check the selected location for the unit. A clear, flat area with
suitable clearance behind the panel is required.
2. Drill or knock out the 4 mounting holes on the unit
3. Fix the appropriate cutting template supplied with the product, to
the selected location, using masking or self-adhesive tape.
4. Using a suitable hole saw (the size is indicated on the template),
make a hole in each corner of the cut-out area.
5. Using a suitable saw, cut along the inside edge of the cut-out line.
6. Ensure that the unit fits into the removed area and then file
around the rough edge until smooth.
7. Drill 4 holes as indicated on the template to accept the securing
screws.
8. Place the gasket onto the display unit and press firmly onto the
flange.
9. Connect the power, data and other cables to the unit.
10. Slide the unit into place and secure using the 4 mounting screws.
Note: The appropriate torque to use when drilling depends on the
thickness of the mounting surface and the type of material.
Note: The supplied gasket provides a seal between the unit and
a suitably flat and stiff mounting surface or binnacle. The gasket
should be used in all installations. It may also be necessary to
use a marine-grade sealant if the mounting surface or binnacle is
not entirely flat and stiff or has a rough surface finish.
Bracket (trunnion) mounting
The display can be mounted on a trunnion bracket.
Before mounting the unit ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the cables will take.
60
• Attached the front bezel.
D12585-1
1. Mark the location of the mounting bracket screw holes on the
chosen mounting surface.
2. Drill holes for the screws using a suitable drill, ensuring there is
nothing behind the surface that may be damaged.
3. Use the screws supplied with the mounting bracket to attach
securely.
4. Attach the display unit to the mounting bracket.
Note: The appropriate torque to use when drilling depends on the
D12588-1
thickness of the mounting surface and the type of material.
Front bezel
Attaching the front bezel
The following procedure assumes that the unit has already been
mounted in position.
1. Carefully lift one edge of the screen protection film, so that it is
accessible for removing when unit installation is complete.
2. Ensure the memory card slot door is in the open position.
3. Orientate the bottom-right side of the bezel under the lip of the
chart card door and place the bezel over the front of the display,
New a Series / New c Series / New e Series
D12578-1