Camera Control - Raymarine a65 Installation And Operation Instructions Manual

Note: The thermal camera menu options available are dependant
on the software version of your multifunction display and thermal
camera. If options are different than listed above please refer to
the manual that accompanied your thermal camera and / or the
installation and operations handbook which accompanied your
multifunction display.
222
• JCU Icon
• PC Icon
• Restore Factory Defaults
• Calibrate Platform

19.4 Camera control

Power up and standby
When the breaker connecting power to the camera is switched on,
the camera will run a boot up sequence lasting for about 1 minute,
after which the camera will be in Standby mode.
In order for the camera to operate, you must bring the camera out
of standby mode using the camera controls.
Thermal camera standby
Standby mode can be used to temporarily suspend the thermal
camera's functions when the camera is not needed for a prolonged
period.
When in standby mode the camera:
• Does NOT provide a live video image.
• Moves the camera into its "stowed" (parked) position (lens facing
down into the camera base) to protect the camera optics.
• Engages its pan / tilt motors to hold the camera in place in rough
seas.
Note: The "stowed" (parked) position can be configured using the
camera's setup menu.
Enabling and disabling thermal camera standby
With the thermal camera application displayed:
1. Select Menu.
2. Use the Standby menu item to switch the camera in and out
of standby mode.
Note: You can also use any of the camera controls in the thermal
camera application to "wake" the camera from standby mode.
Pan, tilt and zoom
The camera controls allow for pan and tilt (elevation) of the camera,
as well as zoom (magnification) of the thermal image.
• Pan continuously through 360º.
• Tilt (elevate) to ±90º relative to the horizon.
• Zoom (magnify) the thermal camera image.
Note: Stabilized variants of the T-Series thermal cameras include
a continuous zoom function, non-stabilized variants can switch
between x2 and x4 magnification.
New a Series / New c Series / New e Series
D11973-1