Using A Dsc Vhf Radio With Your Display; Enabling Dsc Vhf Radio Integration - Raymarine a65 Installation And Operation Instructions Manual

24.1 Using a DSC VHF radio with your
display
You can connect your DSC VHF radio to your multifunction display
and show distress message information and GPS position data for
other vessels.
Connecting a DSC VHF radio to your multifunction display provides
the following additional functionality:
• Distress Messages — when your DSC VHF radio receives a
DSC message or alarm from another DSC VHF radio-equipped
vessel, the vessel identification (MMSI), GPS position, and time of
distress message is displayed on your multifunction display. With
the distress message displayed you can use the buttons provided
to: clear the message, place a waypoint on the chart at the GPS
position of the distressed vessel, or immediately start navigating
(GOTO) to the GPS position of the distressed vessel.
• Position Data — the "Position Request" button on your DSC VHF
radio enables you to send and receive GPS position data to and
from other vessels equipped with a DSC VHF radio.
For information on installing and operating your DSC VHF radio,
refer to the handbook that accompanies the radio.
The following image shows an example of a distress message
displayed on a multifunction display:
250

24.2 Enabling DSC VHF radio integration

With the homescreen displayed:
1. Select Set-up.
2. Select System Settings.
3. Select DSC Alerts > ON.
Note: DSC VHF distress messages are only displayed for radios
connected via NMEA 0183. DSC VHF distress messages are
NOT displayed for SeaTalk radios connected to the display via
the SeaTalk to SeaTalkng converter.
New a Series / New c Series / New e Series