Compact Flash And Status Leds; Ethernet Ports And Status Leds - Cisco ASR 9000 Series Installation Manual

Chapter 4 Troubleshooting the Installation
Table 4-5 RP Discrete LED Display Definitions (continued)
Indicator (Label) Color
GPS Green
Off
(Default after reset)

Compact Flash and Status LEDs

One compact flash slot provides the RSP with additional flash memory capacity. All combinations of
different flash devices are supported by the RSP. You can use ATA flash disks, Type 1 or Type 2 linear
flash memory cards, or a combination of the two.
Note The RSP only supports +5.2 VDC flash memory devices. It does not support +3.3 VDC PCMCIA
devices.
The RSP-440 and RP do not have a compact flash slot.
Note
The slot has an eject button (located behind the cover) to remove a flash card from the slot.

Ethernet Ports and Status LEDs

The RSP/RP has two 8-pin media-dependent interface (MDI) RJ-45 Management LAN ports for
100 Mbps and 1000Mbps Ethernet connections. These ports are labeled MGT LAN 0 and MGT LAN 1.
The transmission speed of the Ethernet port is not user-configurable. You set the speed through an
autosensing scheme on the RSP/RP, which determines the speed by the network that the Ethernet port is
connected to. However, even at an autosensed data transmission rate of 100 Mbps, the Ethernet port can
only provide a usable bandwidth of substantially less than 100 Mbps. You can expect a maximum usable
bandwidth of approximately 12 Mbps when using an Ethernet connection.
The following LEDs on the front panel indicate traffic status and port selection (see
•
•
Note
Description
GPS interface provisioned and ports are turned on. ToD, 1 PPS, 10 Mhz are
all valid.
Either the interface is not provisioned, or the ports are not turned on. ToD, 1
PPS, 10 Mhz are not valid.
LINK—Indicates link activity.
ACT—Indicates which Ethernet port is selected (ETH 0 or ETH 1).
Because both ports are supported on the RSP/RP card, MGT LAN 0 is always on. MGT LAN 0
lights when it is selected.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Troubleshooting the Route Processor Subsystem
Figure 4-6):
4-23