Positioning The Router; Positioning The Cisco Asr 9010 Router, Cisco Asr 9006 Router, And Cisco 9904 Router; Positioning The And Cisco Asr 9922 Router And Cisco Asr 9912 Router - Cisco ASR 9000 Series Installation Manual

Chapter 2 Unpacking and Installing the Chassis

Positioning the Router

Positioning the Cisco ASR 9010 Router, Cisco ASR 9006 Router, and Cisco 9904 Router

Use a safety hand truck to move the Cisco ASR 9010 Router, Cisco ASR 9006 Router, or
Cisco ASR 9904 Router router to its final location for rack installation.

Positioning the and Cisco ASR 9922 Router and Cisco ASR 9912 Router

TheCisco ASR 9922 Router and Cisco ASR 9912 Router and each ship in a carton similar to the CRS-1
16-Slot shipping carton. Each chassis is installed in a shipping rack used only for shipping purposes.
Remove the chassis from the shipping rack before installing it into the rack.
To prepare the 19-inch 45-RU rack:
Install the two guide rails onto the bottom of the rack.
Step 1
The guide rails are included with the ASR-9922-ACC-KIT and ASR-9912-ACC-KIT accessory kits.
Each accessory kit ships with the chassis and includes the guide rails, grounding lug, associated
hardware, and a warranty card.
Use screws to fasten these two guide rails onto the front and rear rails of the rack.
Step 2
The two guide rails at the bottom of the rack (see
accommodate 12-24 or M6 screws. If you are using smaller 10-32 screws, you must use bushings to fit
the larger holes (see
Figure 2-13
Note
Remove the shipping carton, plastic covering, rear brackets, attachment screws and bolts, shipping rack
Step 3
bar, and any cosmetic accessories included with the chassis.
Figure 2-13).
One 10-32 Screw with Bushings in Guide Rail Holes
Delrin bushings with part number 17234-D-1 can be obtained from ASM at
www.accuratescrew.com.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Figure 2-8) have six holes (three per rail) that
Unpacking the Router
2-17