Removing A Version 1 Ac Or Dc Power Module - Cisco ASR 9000 Series Installation Manual

Chapter 5 Replacing Cisco ASR 9000 Series Router Components
Confirm your choice.
Step 4
Please confirm that you wish to upgrade from AC power supply version 2 power system to DC
power supply version 2 power system by typing "yes" at the prompt below. Any other
response will cancel the power system change operation [yes/cancel]?
After the success message appears, power down the chassis.
Step 5
start update CBC eeprom, offset = 0x0,length=1000
..............................................................
done update CBC eeprom
start update I2C eeprom
...............................................................
done update I2C eeprom
The power system programming change is complete. The system must now be completely powered
down, and the NEW power system hardware installed. When the system is rebooted the
software will recognize the new power system. Please power down the system at this point.
#
Step 6 Remove the old power module (see the
page 5-13
Use two hands to remove the power module. The power supply weighs about 6.5 pounds (2.95 kg).
Caution
Install the new power module (see the
Step 7
page 5-15
To prevent damage to the power tray backplane connector, do not use excessive force when inserting the
Caution
power module into the power tray.
Step 8 Power up the chassis.
Step 9 Verify that the (green) Power Input indicator on the front of the power module goes on. If the indicator
does not light, see the

Removing a Version 1 AC or DC Power Module

Follow these steps to remove a version 1 AC or DC power module from the power tray (see
Push the door latch to the left to release the door.
Step 1
Pivot the door to the right to eject the power module from its bay.
Step 2
Slide the power module out of its bay while supporting it with your other hand.
Step 3
Use two hands to remove the power module. The power supply weighs about 6.5 pounds (2.95 kg).
Caution
yes
or the "Removing a Version 2 AC or DC Power Module" section on page
or the "Installing a Version 2 AC or DC Power Module" section on page
"Troubleshooting the Power Subsystem" section on page
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Removing and Replacing Power System Components
"Removing a Version 1 AC or DC Power Module" section on
"Installing a Version 1 AC or DC Power Module" section on
5-14).
5-15).
4-7.
Figure 5-8).
5-13