Cisco ASR 9000 Series Installation Manual page 112

Removing Cards from the Chassis
Figure 2-30
a
b
c
d
b
a
c
a Loosen the captive screws.
b Push in both ejector lever
release buttons.
To remove a RP or line card (see
Step 3
Use a screwdriver to loosen the captive screws at the ends of the line card front panel.
a.
Pivot the ejector levers to unseat the card from the backplane connector.
b.
Slide the card out of the slot and place it directly into an antistatic bag or other ESD-preventive
c.
container.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
2-38
Removing a Fabric Card from the Cisco ASR 9912 Router Chassis
c Pivot the ejector levers outward to unseat the card from the
backplane connector.
d Slide the card out of the chassis.
Figure 2-31
Chapter 2
or Figure 2-32), starting at the lowest numbered slot:
Unpacking and Installing the Chassis