Troubleshooting Rsp And Rp Cards - Cisco ASR 9000 Series Installation Manual

Chapter 4 Troubleshooting the Installation
Note
Table 4-6
Table 4-6
Compact Flash Disk Size
1 GB

Troubleshooting RSP and RP Cards

When the router is powered on, the alphanumeric display on the RSP indicates the following sequence:
INIT—Card is inserted and microcontroller is initialized.
BOOT—Board is powered on and CPU is booting.
IMEM—Start initializing memory.
IGEN—Start initializing the board.
ICBC—Start initializing communication with the microcontroller.
PDxy—Loading programmable devices (x = FPGA, y = ROMMON).
PSTx—Power on self test x.
RMN—All tests are finished and ROMMON is ready for commands.
LOAD—Downloading Minimum Boot Image (MBI) image to CPU.
MBI—Starting execution of MBI.
IOXR—Cisco IOS-XR software is starting execution.
ACTV—RSP role is determined to be active RSP.
STBY—RSP role is determined to be standby RSP.
PREP—Preparing disk boot.
When the router is powered on, the alphanumeric display on the RSP-440 and RP indicates the following
sequence:
INIT—Card is inserted and microcontroller is initialized
BOOT—Board is powered on and CPU is booting
IMEM—Start initializing memory
IGEN—Start initializing the board
ICBC—Start initializing communication with the microcontroller
SCPI—Board is not plugged in properly
STID—CBC was unable to read slot ID pins correctly
PSEQ—CBC detected power sequencer failure
DBPO—CBC detected an issue during board power up
KPWR—CBC detected an issue during board power up
LGNP—CBC detected an issue during board power up
The RSP-440 and RP do not have a compact flash slot.
lists supported compact flash disk sizes and Cisco part numbers.
Supported Compact Flash Disk Sizes
Part Number
16-3204-01
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Troubleshooting the Route Processor Subsystem
4-25