Installing Fc Cards In The Chassis; Installing Line Cards In The Chassis - Cisco ASR 9000 Series Installation Manual

Chapter 3 Installing Cards and Modules in the Chassis

Installing FC Cards in the Chassis

Follow these steps to reinstall FC cards into the Cisco ASR 9922 Router (see
numbering) and Cisco ASR 9912 Router (see
Starting at slot FC0, slide the card into the slot.
Step 1
Pivot the ejector levers to seat the card to the backplane connector.
Step 2
Do not apply excessive force to the FC card to seat it. When seated, the FC card ejector levers are angled
Caution
slightly outward from the card faceplate (item 1 in
fully tightened, the ejector levers are parallel to the card faceplate (item 2 in
in the backplane is normal. When you push the ejector levers fully vertical, the card is seated in the
backplane connectors. However, when you release the levers, backplane flexing pushes the levers out,
so the levers may be slightly loose. Tightening the captive installation screws prevents any additional
movement from flexing of the backplane.
Step 3 Tighten the captive screws at the top and bottom of the front panel to a torque of 10 +/–1 in-lb.
Repeat
Step 4
Even when the FC card is fully seated with installation screws fully tightened, there may be a slight gap
Note
between the card and the chassis (item 3 in

Installing Line Cards in the Chassis

Before you begin reinstalling cards in the card cage, identify slot assignments by referring to the written
list you prepared when you removed the cards (see
Figure 2-28
Be careful to avoid damaging the EMI gasket that runs along the full height of the card front panel edges.
Caution
Damage to the EMI gasket can affect the ability of your system to meet EMI requirements.
Follow these steps to reinstall line cards in the chassis card cage:
Starting at the lowest numbered line card slot, slide the card into the slot (see
Step 1
Figure
Pivot the ejector levers to seat the card into the backplane connector.
Step 2
Tighten the captive screws at the top and bottom of the front panel to a torque of 10 +/–1 in-lb.
Step 3
Step 1 through Step 3 to install the remaining FC cards into slots FC1 to FC6.
for slot numbering).
3-9, or Figure 3-10) until it mates with the backplane connector.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Figure 2-28 for slot numbering).
Figure 3-4). When the captive installation screws are
Figure 3-4).
Figure 2-20, Figure
Installing Cards in the Chassis
Figure 2-27 for slot
Figure 3-4). Some flexing
2-22, and Figure 2-27, and
Figure 3-6, Figure 3-7,
3-11