Table of Contents
Advertisement
Depending on the speed of the Internet connection, it usually takes
from 10 to 20 minutes for the OnPlus Network Agent to be ready
for the initial activation. If the base software image on the device is
current, this step may not take as long.
During this time, the OnPlus Network Agent:
•
Acquires a LAN IP address using DHCP
•
Connects to the Internet and downloads the current base
software image
•
Upgrades its software
You can monitor the progress of the initial startup by looking at the
LEDs on the front panel of the unit. See the
Agent Status LEDs" section on page 7
The OnPlus Network Agent is ready for activation when the
S
4
TEP
STATUS 1 LED on the front panel is lit Steady Green and the
STATUS 2 LED is Off.
IMPORTANT
Amber and Blinking Amber for more than two minutes, this
indicates that the OnPlus Network Agent has failed to obtain an IP
address using DHCP. Make sure that the DHCP server is
functioning and that IP addresses are available in the DHCP pool.
To continue, go to
Cisco OnPlus Portal, page
OnPlus Network Agent Status LEDs
6
The STATUS 1 and STATUS 2 LEDs on the front panel of the
OnPlus Network Agent indicate the progress of the device during power
on, restart, software upgrade, and reset operations.
Status LEDs
Power On and Initialization
1
Steady Amber
STATUS
2
Steady Amber
1
2
Cisco ON100 Network Agent Quick Start Guide
If the STATUS 1 and STATUS 2 LEDs are lit Steady
Activating the OnPlus Network Agent with the
9.
Description
Power-on sequence.
"OnPlus Network
for more information.
7
Advertisement
Table of Contents
