Cisco ASR 9000 Series Installation Manual page 268

Be sure that the chassis configuration complies with the required power budgets. Failure to properly
Caution
verify the configuration may result in an unpredictable state if one of the power units fails. Contact your
local sales representative for assistance.
Table A-8
Table A-8
Description
Power modules per system
Total AC input power per
power module
Rated input voltage per
power module
Rated input line frequency
Input current draw
Source AC service
requirement
Redundancy
1. For each AC power supply module. Some power/chassis configurations may operate at lower current ratings than
those specified in this table. Contact your Cisco technical representative for more information.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
A-6
lists the AC electrical specifications for the Cisco ASR 9006 Router.
Cisco ASR 9006 Router AC Electrical Specifications
Value
Version 1 power system:
Up to three AC power modules per system
Version 2 power system:
Up to four AC power modules per system
3400 VA (volt-amps) per AC power module
200–240 VAC nominal (range: 180 to 264 VAC)
220–240 VAC (UK)
1
50/60 Hz nominal (range: 47 to 63 Hz)
50/60 Hz (UK)
1
15 A maximum at 200 VAC
13 A maximum at 220 to 240 VRMS (UK)
20 A North America; 16 A international;
1
13 A United Kingdom
At least two AC power modules are required for N+1 redundancy
for a fully configured system (version 1 and version 2).
Appendix A Technical Specifications