Cisco ASR 9000 Series Installation Manual page 208

Troubleshooting Overview
Table 4-2 Alphanumeric Displays and LEDs at System Startup (continued)
Component Type of Indicator
RP card Alphanumeric
display
AC Power Power status LEDs
Modules
DC Power Power status LEDs
Modules
Fan Trays Fan tray status LED
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
4-6
Display Contents/LED Status and Meaning
INIT—Card is inserted and microcontroller is initialized
BOOT—Board is powered on and CPU is booting
IMEM—Start initializing memory
IGEN—Start initializing the board
ICBC—Start initializing communication with the microcontroller
SCPI—Board is not plugged in properly
STID—CBC was unable to read slot ID pins correctly
PSEQ—CBC detected power sequencer failure
DBPO—CBC detected an issue during board power up
KPWR—CBC detected an issue during board power up
LGNP—CBC detected an issue during board power up
LGNI—CBC detected an issue during board power up
RMN—All tests are finished and ROMMON is ready for commands
LOAD—Downloading MBI image to CPU
RRST—ROMMON is performing a soft reset after 5 consecutive MBI validation
requests timed out
MVB—ROMMON trying MBI validation boot
MBI—Starting execution of MBI
IOXR—Cisco IOS XR software is starting execution
LDG—The RP is loading (MBI started and card preparing for activity)
INCP—The software or configuration is incompatible with the RP
OOSM—The RP is in Out of Service, Maintenance mode
ACTV—RP role is determined to be active RP
STBY—RP role is determined to be standby RP
PREP—Preparing disk boot
Input power indicator on (green): Input AC power OK.
Output power indicator on (green): Output DC power OK.
Fault LED off (red): No fault is present.
The correct power module voltages are present and no faults have been detected.
Input power indicator on (green): Input DC power OK.
On the DC power tray, the Power Input LED is lit solid green if both DC feeds
are valid and blinks green if only a single DC feed is valid.
Output power indicator on (green): Output DC power OK.
Fault LED off (red): No fault is present.
The correct power module voltages are present and no faults have been detected.
Green LED on: Fan Tray OK.
The fan tray fans are operating correctly.
Chapter 4 Troubleshooting the Installation