Fc Card Front Panel Indicator; Troubleshooting Line Cards And Modular Port Adapters; Monitoring Critical, Major, And Minor Alarm Status - Cisco ASR 9000 Series Installation Manual

Chapter 4 Troubleshooting the Installation
Table 4-7
Message
PST1
PST2
PST3

FC Card Front Panel Indicator

The front panel of the FC card has one tri-color LED indicator for system information.
Table 4-8
Table 4-8 FC Card LED Display Definitions
Indicator (Label) Color
Power Fail Green
(FAIL)
Red
Amber
Off
(Default after reset)

Troubleshooting Line Cards and Modular Port Adapters

See the
information about troubleshooting line cards and modular port adapters (MPA).

Monitoring Critical, Major, and Minor Alarm Status

The alarms can warn of:
•
•
•
•
•
The alarm LEDs are controlled by the CAN microcontroller software, which sets the threshold levels for
triggering the different stages of alarms.
Troubleshooting Using the RSP Alphanumeric Display Messages
Description
Failed DDR RAM memory test
Failed FPGA image CRC check
Failed board type and slot ID verification
lists the display definitions of the discrete LED on the FC card front panel.
Description
FC card powered on and FPGA is programmed.
Note
Fault or malfunction in FC card power up or FPGA programming.
Note
FC card powered on but fabric not active.
FC card powered off via CLI.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Overtemperature condition on a component in the card cage
Fan failure in a fan tray
Overcurrent condition in a power supply
Out-of-tolerance voltage on one of the cards
Insertion count for an RSP, RP, FC, or line card has reached a specified threshold. For more
information on OIR insertion counts, see the
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Fabric Data Link failure is not detected so LED remains green.
Monitor CLI messages for status.
Once any ejector lever release button is pushed in, the FC card must
be physically removed and reinserted (OIR) to restart the FC card.
During this time before the FC card is restarted, the LED is red.
"OIR Monitoring" section on page
Troubleshooting the Route Processor Subsystem
5-3.
for
4-27