Cisco ASR 9000 Series Installation Manual page 140

Installing Chassis Accessories
Figure 2-55
1
1
Install each hinge bracket, with an L-shaped
bracket attached, using four screws.
Install the mid-cover with door lock (item 6 in
Step 7
and lining up the grooves in the top outside edges of the mid-cover with ridges at the bottom of the hinge
brackets.
Attach two doors to the hinge brackets (one per side). For each door:
Step 8
Align the door hinge hole with the bracket hinge hole (see
a.
Insert the captive pin in the door hinge through the hole in the bracket hinge.
b.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
2-66
Installing the Hinge Brackets and L-Shaped Brackets on the Cisco ASR 9010 Router
2
Chapter 2 Unpacking and Installing the Chassis
2 After the hinge brackets are installed, secure
each L-shaped bracket to the cable
management tray and chassis with the screw
that you previously removed from that
location.
Figure 2-53) by engaging it to the upper four ball studs
Figure 2-56).