Cisco ASR 9000 Series Installation Manual page 110

Removing Cards from the Chassis
Figure 2-28
Power shelves/trays
Follow these steps to remove FC, RP, and line cards from the Cisco ASR 9922 Router and
Cisco ASR 9912 Router chassis.
Use Figure 2-27
Step 1
on a piece of paper. You will need this information when you reinstall the cards in the chassis to be sure
you reinstall each card in its original slot.
To remove a FC card (see
Step 2
Remove the air filter covering the front of the middle cage.
a.
Use a screwdriver to loosen the captive screws at the ends of the FC card front panel.
b.
Push in both ejector lever release buttons.
c.
Note
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
2-36
Cisco ASR 9912 Router Components and Slot Numbering with Version 2 Power
System
Fan trays
(rear instertion)
Line cards
PS0
PS1
PS2
Power modules
or Figure 2-28 to identify each card and then write down the card type and slot number
Figure 2-29
Once any ejector lever release button is pushed in, the FC card must by physically removed and
reinserted (OIR) to restart the FC card.
FT0
FT1
M0 M1 M2 M3
M4 M5 M6 M7
M8 M9 M10 M11
or Figure 2-30), starting at the lowest numbered slot:
Chapter 2 Unpacking and Installing the Chassis