Cisco ASR 9000 Series Installation Manual page 269

Appendix A Technical Specifications
Table A-9
Table A-9
Description
Power modules per system
Total AC input power per
power module
Rated input voltage per
power module
Rated input line frequency
Input current draw
Source AC service
requirement
Redundancy
1. For each AC power supply module. Some power/chassis configurations may operate at lower current ratings than
those specified in this table. Contact your Cisco technical representative for more information.
Both the AC-powered and DC-powered versions of the Cisco ASR 9904 Router support only
Table A-10
Table A-10
Description
Power modules per system
Total AC input power per
power module
Rated input voltage per
power module
Rated input line frequency
Input current draw
lists the AC electrical specifications for the Cisco ASR 9904 Router.
Cisco ASR 9904 Router AC Electrical Specifications
Value
Version 2 power system
Up to four AC power modules per system
3400 VA (volt-amps) per AC power module
200–240 VAC nominal (range: 180 to 264 VAC)
220–240 VAC (UK)
1
50/60 Hz nominal (range: 47 to 63 Hz)
50/60 Hz (UK)
1
15 A maximum at 200 VAC
13 A maximum at 220 to 240 VRMS (UK)
20 A North America; 16 A international;
1
13 A United Kingdom
At least two AC power modules are required for N+1 redundancy
for a fully configured system.
version 2 power systems.
lists the AC electrical specifications for the Cisco ASR 9922 Router.
Cisco ASR 9922 Router AC Electrical Specifications
Value
Version 2 power system:
Up to 16 AC power modules per system, four per tray
3400 VA (volt-amps)
200–240 VAC nominal (range: 180 to 264 VAC)
220–240 VAC (UK)
1
50/60 Hz nominal (range: 47 to 63 Hz)
50/60 Hz (UK)
1
15 A maximum at 200 VAC
13 A maximum at 220 to 240 VRMS (UK)
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
A-7