Powering On The Router - Cisco ASR 9000 Series Installation Manual

Chapter 3 Installing Cards and Modules in the Chassis
Replace the clear plastic safety covers over the connection terminal studs.
Step 5
Figure 3-25
Proceed to the
Step 6

Powering On the Router

Follow these steps to turn on power to an AC-powered or DC-powered router:
Power on the circuit breaker to your power sources.
Step 1
Verify that the Power Input LED on each power module in the tray is lit.
Step 2
Note
Set the power tray switch for Feed A Slots M03 to the ON (1) position. For the feeds, see
Step 3
for Version 1 power systems and
switch, refer to
Verify that the Power Output LED on each power module in the tray is lit.
Step 4
Repeat
Step 5
Typical Plastic Safety Cover over the Power Tray Connection Terminals—Version 2
Power System
"Powering On the Router" section on page
On the DC power tray, the Power Input LED is lit solid green if both DC feeds are valid and
blinks green if only a single DC feed is valid.
Figure 3-23
Figure 3-22 for Version 1 power systems and
Step 3 and Step 4 for Slots M03 for Feed B.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
3-31.
for Version 2 power systems. For the locations of the power
Figure 3-24

Powering On the Router

Figure 3-21
for Version 2 power systems.
3-31