Configuration - Bosch DCN Next Generation Installation And Operation Manual

Conference System
7

Configuration

7.1 System Configuration
7.1.1 Downloading
To download the software to a CCU, do the following:
1.
2.
3.
4.
5.
6.
To download the software to a multi-CCU, do the following:
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTICE!
The Download and License Tool can be used for upgrading. When "Download Optical devices"
is selected, all applicable devices connected to the optical network will be upgraded. In case
the DCN-WAP is connected, it will take more than 50 minutes to upgrade the DCN-WAP.
Bypass: In case the DCN-WAP does not need to be upgraded, do not connect the DCN-WAP
when selecting "Download Optical devices". This is normal system behavior; it is mentioned
here to remind the user.
NOTICE!
For the system to work correctly, all software and firmware of the central equipment and PC
must be of the same release.
Bosch Security Systems B.V.
Install the download and license tool on a PC (the download and license tool is on the
DVD).
Connect all central equipment with an optical network connector to the CCU. Be aware
of ground-loop settings (refer to Section 3.1 DCN-CCU2 and DCN-CCUB2 Central Control
Units.)
Connect the CCU to the PC.
Power-up the CCU and all other central equipment.
Select: Download CCU.
Select: Download optical devices.
Install the download and license tool on a PC (the download and license tool is on the
DVD).
Connect all central equipment to the master CCU except for the slave CCU.
Connect the master CCU to the PC.
Select: Download CCU.
Select: Download optical devices.
Power off the master CCU and the optical devices.
Connect the CCUs, one at a time, to the PC.
Select: Download CCU.
Power off the CCUs, one at a time.
Installation and Operation manual
Configuration | en 173
DCN-NG_IOM_V4.1 | V1.3 | 2012.07