Cnconfig - Bosch DCN Next Generation Installation And Operation Manual

198 en | Configuration
7.8

CNConfig

Install the CNConfig on a PC with the DVD that is supplied with your system. The DVD
contains an automatic set-up program.
With the Advanced Configuration window, you can change the values of the CobraNet
parameters of the CobraNet devices. To open the Advanced Configuration window, double-
click on the CobraNet device in the CobraNet Settings window (refer to Figure 7.11).
NOTICE!
Do not use the Advanced configuration window to set IP addresses to CobraNet devices.
Always use CobraNet Discovery to set IP addresses to CobraNet devices.
Figure 7.8 Advanced configuration window
Conductor and clock
When the CobraNet device is an LBB4404/00 CobraNet Interface, make sure that you set:
–
–
When the CobraNet device is an LBB4404/00 CobraNet Interface, these parameters are not
applicable:
–
–
–
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
Conductor clock to Internal clock.
Perform clock to Internal clock.
Locked on external or network clock.
External synchronization present.
Conductor Priority.
Installation and Operation manual
Conference System
Bosch Security Systems B.V.