Bosch DCN Next Generation Installation And Operation Manual page 163

Conference System
Figure 6.79 Mounted socket contacts
Remove the sheath from the optical fibers
Proceed as follows:
14. Put the plastic optical fibers into the POF cutter/stripping tool (tool 6). The optical fiber
Figure 6.80 Cutting a fiber (1)
Figure 6.81 Cutting a fiber (2)
15. Close the tool to hold the cable and pull the 'trigger' to cut the optical fiber.
Bosch Security Systems B.V.
A
that is to be cut must be put in the small guide hole. The other optical fiber must be put
in the large guide hole. Push the cable until the crimping bush is against the stop.
Installation and Operation manual
B
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
Connection | en 163