Bosch DCN Next Generation Installation And Operation Manual page 196

196 en | Configuration
Start - CobraNet Discovery
Make sure that the PC, on which you installed the CobraNet Discovery, is connected to the
CobraNet network. On the PC, go to Start > Programs > CobraNet Discovery. The monitor of
the PC shows the CobraNet (tm) Discovery window.
Operation
The CobraNet (tm) Discovery window shows the CobraNet devices on the CobraNet network
and their Ethernet parameters.
NOTICE!
The list also shows PC in which CobraNet Discovery is installed.
Figure 7.7 CobraNet (tm) Discovery window
The list contains the following data:
1.
2.
3.
4.
5.
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
S(tatus) - Shows the condition of the CobraNet device. If the status column contains a
green checkmark, the device is active. If the status column contains a red cross, the
device is not active or not connected to the network.
MAC Address - Shows the MAC address of the CobraNet device.
IP Address - Shows the IP address of the device. Usually, the IP address of new devices is
0.0.0.0. CobraNet Discovery can automatically give addresses to new devices.
sysDescription - Shows the name and the firmware version of the CobraNet device.
errorCount - Shows the number of errors of the CobraNet device since you started
CobraNet Discovery.
Installation and Operation manual
Conference System
Bosch Security Systems B.V.