Bosch DCN Next Generation Installation And Operation Manual page 201

Conference System
Figure 7.10 Tx Advanced Configuration window
4.
5.
NOTICE!
You can connect an audio output to more than one bundle channel. When you connect an
audio output to more than one bundle channel, the system operates correctly.
6.
7.
Start - CN Config
Make sure that the PC on which you have installed the CNConfig is connected to the CobraNet
network. On the PC, go to Start > Programs > Bosch > CNConfig. The PC monitor shows the
CobraNet Settings window.
Bosch Security Systems B.V.
On the right side of the Bundle Channel 1 block, click the arrow button with the left
mouse button. The CNConfig shows a list of audio outputs that you can connect to the
bundle channel 1.
Click the audio output that must be connected to the bundle channel. When the cobranet
interface must not use the bundle channel, click on Unused with the left mouse button.
Enter the values of the other parameters of the transmitter bundle (refer to the online
help of the CNConfig).
Repeat step 4 to 6 for the other bundle channels in the transmitter bundle.
Installation and Operation manual
Configuration | en 201
DCN-NG_IOM_V4.1 | V1.3 | 2012.07