Bosch DCN Next Generation Installation And Operation Manual page 176

176 en | Configuration
NOTICE!
To open the Setup sub-menu, you must push and hold the knob for more than 3 seconds.
To select menu items in a sub-menu
Do as follows:
–
–
To open a menu item
Do as follows:
–
–
To select a parameter
Do as follows:
1.
2.
3.
4.
5.
To change the value of a parameter
Do as follows:
1.
2.
3.
4.
5.
To close a menu item
Do as follows:
1.
2.
To close a sub-menu
Do as follows:
1.
2.
To close the main menu
Do as follows:
1.
2.
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
Turn the knob clockwise in a sub-menu to go to the next menu item in the sub-menu.
Turn the knob counterclockwise in a sub-menu to go to the previous menu item in the
sub-menu.
Turn the knob to select the applicable menu item.
When the display shows the correct menu item, push the knob to open the menu item.
The display shows a cursor.
Open the correct menu item.
Turn the knob to move the cursor to the parameter that is shown.
On the parameter, push the knob. The parameter flashes.
Turn the knob to go to the applicable parameter.
When the display shows the applicable parameter, push the knob to select the
parameter. The display shows a cursor.
Select the applicable parameter.
Turn the knob to move the cursor to the value.
Push the knob. The value flashes.
Turn the knob to go to the value.
When the display shows the correct value, push the knob to select the value. The display
shows a cursor.
Turn the cursor to the last character that identifies the menu item.
Push the knob to close the menu item. The last character and the menu item title flash.
Turn the cursor to go to the last character but one that identifies the menu item.
Push the knob to close the sub-menu. The last character and the menu item title flash.
From the main menu, turn the primary knob clockwise to go to the < Back menu item.
From the < Back menu item, push the knob to go to the Main menu item.
Installation and Operation manual
Conference System
Bosch Security Systems B.V.