Bosch DCN Next Generation Installation And Operation Manual page 132

132 en | Connection
6.12 DCN-DDI Dual Delegate Interface
Connect the dual delegate interface to the DCN with the DCN cable. You can use the DCN
socket to make a loop-through with the dual delegate interface.
NOTICE!
The power consumption of 4.5 W includes the power consumption of all flush-mounted
devices that you can connect to the dual delegate interface. These are:
• DCN-FLSP
• DCN-FMIC
• DCN-FMICB
• DCN-FPRIOB
• DCN-FV
• DCN-FVCRD
Audio outputs
You can connect loudspeakers to the audio outputs of the dual delegate interface. The
loudspeakers must have 3.5 mm plugs.
Figure 6.31 3.5 mm loudspeaker plug, connection
Number
1
2
3
Table 6.18 3.5 mm loudspeaker plug, connection
Typically, you will connect DCN-FLSP Loudspeaker Panels (refer to Section 3.18 DCN-FLSP
Loudspeaker Panel) to the audio outputs.
Intercom outputs
You can connect an DCN-ICHS Intercom Handset to the dual delegate interface. The intercom
handset must be connected to the intercom socket.
Voting/Control inputs
You can use the voting/control inputs to connect these devices to the dual delegate interface:
–
–
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
2 3 1
Signal
+
Not used
-
DCN-FMICB Microphone Control Panel.
DCN-FPRIOB Priority Panel.DCN-FV(CRD) Voting Panel.
Installation and Operation manual
Conference System
Bosch Security Systems B.V.