Bosch DCN Next Generation Installation And Operation Manual page 160

160 en | Connection
Figure 6.71 Stripping the cable
Crimp the bush
Do as follows:
7.
NOTICE!
The crimping tool (tool 3) makes the circular shape of the cable cross-section and the
crimping bush at the end of the outer sheath into a hexagonal shape. Before you crimp the
bush, make sure that both plastic optical fibers are parallel to a flat side of the hexagonal
cross-section.
Figure 6.72 Cross-section transformation
8.
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
Put the cable end through crimping bush to the end of the outer sheath.
R B
A
B R
A
Use the crimping tool (tool 3) to attach the crimping bush to the outer sheath. The
crimping bush stops the cable from rotating in the connector.
Installation and Operation manual
B
R
B
= Red
R
B = Brown
Conference System
Bosch Security Systems B.V.