Bosch DCN Next Generation Installation And Operation Manual page 162

162 en | Connection
Attach the socket contacts
Do as follows:
11. Put a socket contact in the crimping tool (tool 3). The upper part of the crimping tool
Figure 6.76 Crimping a socket contact (1)
Figure 6.77 Crimping a socket contact (2)
12. Put one of the bare, copper wires into the contact area of the socket contact. Close the
Figure 6.78 Crimping a socket contact (2)
13. Repeat steps 11 and 12 for the other bare copper wire. Refer to the figure to see the
DCN-NG_IOM_V4.1 | V1.3 | 2012.07
contains a ridge to put the socket contact correctly in the tool.
crimping tool to crimp the socket contact onto the copper wire.
result of this part of the cable-connector mounting procedure.
Installation and Operation manual
Conference System
Bosch Security Systems B.V.