Bosch DCN Next Generation Installation And Operation Manual page 145

Conference System
The Kycon KPP-4P plug is shown in parts.
Figure 6.51 Kycon KPP-4P plug, parts
Part
A
B
C
D
E
F
G
H
I
Table 6.30 Kycon KPP-4P plug, parts
You must assemble the connector before you use it.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Push the Metal Spring (D) to the Top Metal Cover (F)/Lower Metal Sleeve (H) assembly.
11. Push the Strain Relief (B)/Plastic Enclosure (C) assembly to the Top Metal Cover (F)/
Bosch Security Systems B.V.
D
E
semi-circular notch
G
F
H
I
arm
slot
'U' section
slotted cut-out
metal tabs
Description
Customer cable
Strain relief
Plastic enclosure
Metal spring
Plastic guide
Top metal cover
Pin mold
Lower metal sleeve
Plastic coupling
Attach the Strain Relief (B) to the Plastic Enclosure (C).
Pull the Cable (A) through the Strain Relief (B)/Plastic Enclosure (C) assembly, Metal
Spring (D) and Plastic Guide Ring (E).
Attach the ends of the cable wires to the solder cups on Pin Mold (G).
Correctly align the Pin Mold (G) with the Lower Metal Sleeve (H). The slotted sections on
the sides of the Pin Mold (G) must align with the slotted cut-outs on the Lower Metal
Sleeve (H). The 3 semi-circular notches around the perimeter of the Pin Mold (G) must
line up with the 3 metal tabs inside the Lower Metal Sleeve (H).
Push the Pin Mold (G) into the Lower Metal Sleeve (H) until they lock.
Push the three metal tabs on the Lower Metal Sleeve (H) into the notches in the Pin Mold
(G).
Crimp the 'U' section of the Lower Metal Sleeve (H) onto the Cable (A).
Attach the Plastic Ring Guide (E) to the Lower Metal Sleeve (H) and engage the plastic
arms into the correct slots in the sides of the sleeve.
Attach the Top Metal Cover (F) to Lower Metal Sleeve (H). Be sure to align all tabs. Make
sure that the cover is attached correctly.
This helps to hold the assembly together.
Lower Metal Sleeve (H) assembly. Align the two assemblies as shown in the drawing.
Installation and Operation manual
A
B
C
Connection | en 145
DCN-NG_IOM_V4.1 | V1.3 | 2012.07