Checking The Event Log In Webpasm - Promise Technology SmartStor NAS Product Manual

SmartStor NAS Product Manual
3. In the Tree, click the File System Management icon.
4. Look for the RAID Volume
If the RAID Volume icon is Critical
contains errors and you must rebuild the file system. See below.
Rebuilding the File System
When you only have read access to your files or no access at all, the File
System might be damaged. This feature checks, and where necessary rebuilds
the File System without loss of data.
You cannot access any data on the SmartStor while the check/rebuild operation
is running.
To rebuild a File System:
1. Click the Administration topic and choose the RAID & File System icon to
expand the Tree.
2. In the Tree, click the File System Management icon.
3. In the File System Status tab, click the RAID Volume Critical icon to display
the Check File System button.
4. Click the Check File System button.
5. In the confirmation box, type yes into the field provided, then click the OK
button.
During the File System Check or Rebuild, the System Status LED blinks
amber and the Disk Activity LEDs blink blue/green. See page 217, Figure 1.
The time needed to check and rebuild the File System depends on the
amount of data on the SmartStor. The process can take anywhere from 10
minutes to 2 hours.

8.7 Checking the Event Log in WebPASM

To view the Event Log in WebPASM:
To check Enclosure status:
1. Start WebPASM.
2. Click the Administration topic and choose the Management icon to expand
the Tree.
3. In the Tree, click the Event Log icon.
The Event Log displays. See Figure 4.
Do not disconnect the power or shut down the SmartStor while
the check/rebuild is running!
icon on the File System Status tab.
(has a yellow!), the file system
Warning
220