Dxv35 Rear Vent Conversion Instructions - Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual

DXV35 REAR VENT CONVERSION INSTRUCTIONS

NOTE:
You must order the Rear Vent Starter Collar Kit #AA-11-00645 from Mendota directly in order to perform this conversion.
The DXV-35, as delivered, comes with the Top Exhaust and Air Intake Collars installed as shown below. The rear Exhaust and Air
Intake ports are plugged. To convert to vent Out-the-rear, please follow these instructions carefully. Pay special attention to the loca-
tions of all Gaskets and Insulation material.
IMPORTANT: Install parts exactly as shown below. Be certain to reuse and properly place gaskets 65-02-00058 and 65-02-00094
removed in Step 2, below. Failure to install gaskets properly will result in Carbon Monoxide emissions and can result in bodily injury
or even death!
PART #
HA-29-00164
HA-29-00165
HA-29-00166
HA-30-00175
35-01-00310
45-01-00253
50-01-00102
45-01-00253
8" AIR INTAKE
COLLAR
AA-11-00645 KIT PARTS IDENTIFICATION
TOP EXHAUST PLUG PLATE
TOP AIR PORT PLUG PLATE
TOP JACKET PLUG PLATE
5" EXHAUST COLLAR
INSULATION
8" AIR INTAKE COLLAR
#8X1/2" TEK SCREWS
35-01-00310
INSULATION
DESCRIPTION
HA-29-00166
TOP JACKET PLUG
HA-29-00165
TOP AIR PORT PLUG
HA-30-00175
5" EXHAUST COLLAR
29
QUANTITY ENCLOSED
1
1
1
1
1
1
12
HA-29-00164
TOP EXHAUST PLUG