Rear Flue Venting Components - Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual

5"X8" DURAVENT VENT PIPES AND COMPONENTS ARE RECOMMENDED
ITEM PART #
(DURAVENT)
1
2
3
4
5
2
3,4
DIRECT REAR VENTING
AGAINST FLAT OUTSIDE WALL
You must use Milpack silicate 1000
pipes and components that do not incorporate a fiberglass or graphite gasket at the joints. High temper-
ature foil tape must be used on the outer (air intake) pipe joints. The Milpak silicate 1000
06-00909) can be ordered through Mendota directly.

REAR FLUE VENTING COMPONENTS

DESCRIPTION
45 º GALVANIZED ELBOW
ADJUSTABLE WALL THIMBLE
6" PIPE (MINIMUM LENGTH)
9" PIPE (MAXIMUM LENGTH)
5"X8" HORIZONTAL VENT CAP
5
Figure 8: Flue Venting Components
o
F stove sealant (#65-06-00909) on all inner pipe joints when using
NOTE: DO NOT SEPARATE TELESCOPING SECTIONS.
THEY MUST BE USED AS COMPLETE ASSEMBLIES.
DIRECT REAR VENTING
CORNER INSTALLATION
23
.
5
2
3,4
1
o
F sealant (#65-