Mendota Designer Fronts Installation Information - Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual

MENDOTA DESIGNER FRONTS INSTALLATION INFORMATION

The following Designer Fronts are available for the DXV-35 Fireplace:
1. Andover, Bentley Arched Door Kit or Prairie Rectangular Door kit with Fire screen with optional Overlays as listed below:
a. Black Overlay
b. Pewter Overlay
c. Antique Copper Overlay
d. 24K Gold
2. Wellington Fire screen Front
3. Black or 24K Gold Victoria Filigree
4. Black or 24K Gold Tuscany Filigree
5. Millennia Flat Grills in four optional color schemes as listed below:
a. Black Millennia Flat Grills
b. Full Brass Millennia Flat Grills
c. Classic Black and Brass Millennia Flat Grills
d. Classic Black and Bright Silver Millennia Flat Grills
Information specific to the installation of the Andover, Bentley and Prairie Fronts
The Andover Door and Prairie Door Fronts are designed to be "Full-Face" trim kits. These two Fronts cover an area equivalent to
that shown in the diagram below. Any material that protrudes into this area on the sides, top or bottom edges can only be flush with
the front surface of the fireplace faceplate.
If planning to install either the Andover Door or the Prairie Door Front, DO NOT COVER THE FACEPLATE OF THE
FIREPLACE WITH ANY MATERIALS. Furthermore, any drywall or wall covering material that is adjacent to the sides, top or
bottom of the Fireplace's faceplate may not protrude out past the front surface of the Fireplace Faceplate's front surface.
The Andover, Bentley and Prairie Doors Mounting Faceplate (required for installation of the Andover, Bentley
and prairie Doors) may be covered over with noncombustible facing materials. See Figure 18, below.
To install Tile, Marble, Slate, Stone, Rocks or
other noncombustible facings to enhance the arch
shape of the Andover Doors or the Rectangular
shape of the Prairie Doors, do so only after the
Andover or Prairie Door Kits have been installed
on the DXV-35 Fireplace.
WARNING: COMBUSTIBLE
MATERIALS MUST NOT COVER
THE FRONT SURFACE OF THE
FIREPLACE'S FACEPLATE.
Figure 17
54